tools:laser_rabbit:techs
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
tools:laser_rabbit:techs [2024/04/12 22:03] – created cookienoyousei | tools:laser_rabbit:techs [2024/04/26 22:31] (current) – [Maintenance & Troubleshooting] cookienoyousei | ||
---|---|---|---|
Line 22: | Line 22: | ||
- Power off the Laser | - Power off the Laser | ||
- Close Lightburn & don’t forget your USB! | - Close Lightburn & don’t forget your USB! | ||
- | - Note any maintenance needs or concerns on the tag and at protohaven.org/ | + | - Note any maintenance needs or concerns on the tag and at [[protohaven.org/ |
+ | |protohaven.org/ | ||
+ | ]] | ||
Consult the [[tools: | Consult the [[tools: | ||
Line 38: | Line 39: | ||
**[[tools: | **[[tools: | ||
- | * One of the most common issues is the lens and mirror get dirty after frequent use | + | * One of the most common issues is the lens and mirror get dirty after frequent use. |
- | * The laser may also be bumped out of alignment. | + | * The focus distance to the material might be incorrectly calibrated. |
+ | * The mirrors | ||
====== Safety ====== | ====== Safety ====== | ||
Line 45: | Line 47: | ||
**Common Hazards** | **Common Hazards** | ||
- | ^Fire ^ Toxic Fumes ^ Lens Collision^ | + | * Fire |
+ | * Toxic Fumes | ||
+ | * Lens Collision | ||
Check to make sure the material is acceptable. | Check to make sure the material is acceptable. |
tools/laser_rabbit/techs.1712959422.txt.gz · Last modified: 2024/04/12 22:03 by cookienoyousei