tools:laser_rabbit:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tools:laser_rabbit:start [2024/06/08 00:42] – [Maintenance Requests] workshop | tools:laser_rabbit:start [2024/12/28 18:03] (current) – [Maintenance Requests] airtable -> http://protohaven.org/maintenance kathryn.mazaitis | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| * Manual: [[: | * Manual: [[: | ||
| * Clearance Required: [[tools: | * Clearance Required: [[tools: | ||
| + | * As of Dec 2024, Laser 1: 100W, laser 2: 80W | ||
| A laser cutter is used to mark, engrave, or cut a wide variety of materials. They work a lot like printers do, where you send a graphic to print. Instead of ink, the laser uses heat to transfer the image onto the material. | A laser cutter is used to mark, engrave, or cut a wide variety of materials. They work a lot like printers do, where you send a graphic to print. Instead of ink, the laser uses heat to transfer the image onto the material. | ||
| Line 195: | Line 196: | ||
| * 🟡Yellow can be used with caution | * 🟡Yellow can be used with caution | ||
| * ⛔Red cannot be used without hazard to either the user or the equipment | * ⛔Red cannot be used without hazard to either the user or the equipment | ||
| - | * Record issues at the [[https://airtable.com/appbIlORlmbIxNU1L/ | + | * Record issues at the [[http://protohaven.org/maintenance|Tool Report]]. This notifies our staff and volunteer maintenance crew of any issues. |
| ===== Troubleshooting ===== | ===== Troubleshooting ===== | ||
tools/laser_rabbit/start.1717807363.txt.gz · Last modified: by workshop