tools:clausing_mill:start
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
tools:clausing_mill:start [2024/03/23 15:40] – [Quick demo notes 2023-11-26] smartin015 | tools:clausing_mill:start [2024/03/25 03:45] (current) – [Video Demos] smartin015 | ||
---|---|---|---|
Line 4: | Line 4: | ||
The Clausing Kondia CNC mill is a machine that can cut machine nearly anything. | The Clausing Kondia CNC mill is a machine that can cut machine nearly anything. | ||
+ | |||
+ | Unfortunately, | ||
+ | |||
+ | ===== Video Demos ===== | ||
+ | |||
+ | Turning on the machine, referencing axes, running a job: [[https:// | ||
+ | |||
+ | Transferring files from your computer to the machine: [[https:// | ||
===== Turning it on and getting it ready to use ===== | ===== Turning it on and getting it ready to use ===== | ||
Line 200: | Line 208: | ||
* Potential upgrades: more memory or a drip feed system (drip feed requires a $1500 firmware upgrade by calling dynapath) or a floppy disk emulator. | * Potential upgrades: more memory or a drip feed system (drip feed requires a $1500 firmware upgrade by calling dynapath) or a floppy disk emulator. | ||
* Spindle actual speed never matches on the display | * Spindle actual speed never matches on the display | ||
+ | * The display interface doesn' | ||
Line 210: | Line 219: | ||
* With a hand over the e-stop, press the Cycle Start button. Slowly raise the feed rate override until you reach the desired speed. | * With a hand over the e-stop, press the Cycle Start button. Slowly raise the feed rate override until you reach the desired speed. | ||
* When the program finishes, it will attempt to move back to machine zero. If you allow it to do this, the machine will not enable jogging until.... ? | * When the program finishes, it will attempt to move back to machine zero. If you allow it to do this, the machine will not enable jogging until.... ? | ||
+ | |||
+ | |||
+ | Todo | ||
+ | |||
+ | * Adjust oil line so knee can travel higher | ||
+ | * Add a mark for 100% feed rate on feed rate override | ||
+ | * Play with the tachometer to check spindle speed vs actual |
tools/clausing_mill/start.1711208402.txt.gz · Last modified: 2024/03/23 15:40 by smartin015