tools:metals_slip_roll:clearance
Differences
This shows you the differences between two versions of the page.
tools:metals_slip_roll:clearance [2024/02/13 07:56] – created system | tools:metals_slip_roll:clearance [2024/03/21 07:54] (current) – smartin015 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Electric Slip Roll Clearance (STUB) ====== | + | ====== Electric Slip Roll Clearance (DRAFT) ====== |
{{section> | {{section> | ||
Line 24: | Line 24: | ||
TODO | TODO | ||
+ | |||
+ | ===== Notes ===== | ||
+ | |||
+ | * check your sleeves & loose fabric - bad! | ||
+ | * Don't do rod or tubing. Sheet metal 16ga only | ||
+ | * Blue bar is emergency stop, works in either direction | ||
+ | * Lower idler roll in the back with the black handles - match sizes | ||
+ | * Want metal going in and up, not digging in. | ||
+ | * Back out both E stops (on machine and on pedestal) | ||
+ | * Press power button, green light turns on | ||
+ | * Make sure tension knobs on both sides are consistent - for top and bottom front roller | ||
+ | * In/out step levers | ||
+ | * Pull the lock on the right side of the top roll out to allow removing fully rounded pieces. Make sure to lock it afterwards! | ||
+ | * Drill slip controler | ||
+ | * Maintenance: | ||
+ | * Every month - apply ways oil (from oil can resting on lathe) to metal bushings on idle roller. Spin the roller to make sure it moves freely | ||
+ |
tools/metals_slip_roll/clearance.txt · Last modified: 2024/03/21 07:54 by smartin015