Protohaven Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Turret Punch Clearance (DRAFT) ======

{{section>tools:clearance_template&noheader&nofooter}}

====== Tool Specific Instruction ======

===== Point out the following tool features =====

TODO

===== Identify & mitigate common hazards =====

TODO

===== Allowable Materials =====

TODO

===== Safe Setup/Operation/Cleanup =====

TODO

===== Knowledge and Technique =====

TODO

===== Notes =====

  * Hole size gauge on the right side matches to pin names
  * Insert changing handle into square slots, push orange ball away to allow for movement. Make sure it locks into place, otherwise you'll damage the pin
  * Too close to an edge causes the sheet metal to buckle 
  * Put in material, bring lever down
  * Upgrades
  * Hook for hanging the changing lever
  * Thick steel bolster plate with holes in it for preventing buckling on turret punch