Differences

This shows you the differences between two versions of the page.

--- tools:metal_turret_punch:clearance [2024/02/13 12:55] – created system
+++ tools:metal_turret_punch:clearance [2024/03/21 11:59] (current) – smartin015
@@ Line 1: / Line 1: @@
-====== Turret Punch Clearance (STUB) ======
+====== Turret Punch Clearance (DRAFT) ======
 {{section>tools:clearance_template&noheader&nofooter}}
@@ Line 24: / Line 24: @@
 TODO
+===== Notes =====
+  * Hole size gauge on the right side matches to pin names
+  * Insert changing handle into square slots, push orange ball away to allow for movement. Make sure it locks into place, otherwise you'll damage the pin
+  * Too close to an edge causes the sheet metal to buckle
+  * Put in material, bring lever down
+  * Upgrades
+  * Hook for hanging the changing lever
+  * Thick steel bolster plate with holes in it for preventing buckling on turret punch