tools:metal_turret_punch:clearance
Differences
This shows you the differences between two versions of the page.
tools:metal_turret_punch:clearance [2024/02/13 07:55] – created system | tools:metal_turret_punch:clearance [2024/03/21 07:59] (current) – smartin015 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Turret Punch Clearance (STUB) ====== | + | ====== Turret Punch Clearance (DRAFT) ====== |
{{section> | {{section> | ||
Line 24: | Line 24: | ||
TODO | TODO | ||
+ | |||
+ | ===== Notes ===== | ||
+ | |||
+ | * Hole size gauge on the right side matches to pin names | ||
+ | * Insert changing handle into square slots, push orange ball away to allow for movement. Make sure it locks into place, otherwise you'll damage the pin | ||
+ | * Too close to an edge causes the sheet metal to buckle | ||
+ | * Put in material, bring lever down | ||
+ | * Upgrades | ||
+ | * Hook for hanging the changing lever | ||
+ | * Thick steel bolster plate with holes in it for preventing buckling on turret punch |
tools/metal_turret_punch/clearance.txt · Last modified: 2024/03/21 07:59 by smartin015