tools:metal_shear:clearance
Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
tools:metal_shear:clearance [2024/02/13 12:52] – created system | tools:metal_shear:clearance [2024/03/21 11:54] (current) – smartin015 | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Shear Clearance (STUB) ====== | + | ====== |
{{section> | {{section> | ||
====== Tool Specific Instruction ====== | ====== Tool Specific Instruction ====== | ||
+ | |||
+ | TODO | ||
===== Point out the following tool features ===== | ===== Point out the following tool features ===== | ||
Line 24: | Line 26: | ||
TODO | TODO | ||
+ | |||
+ | ===== Notes ===== | ||
+ | |||
+ | * Measuring - via the guard/ | ||
+ | * Too small of pieces fall down into the machine, better off to add a spacer piece to keep thing from falling | ||
+ | * To remove pieces that fall in - remove the back plywood board and dig | ||
+ | * Plywood outfeed board catches stuff so it doesn' | ||
+ | * Confirm both E stops (on machine and on pendant) are disengaged | ||
+ | * Make sure plugged in, Turn red lever to turn machine on | ||
+ | * Pump start button, runs the hydraulic pump | ||
+ | * Push metal to the guard, step on the pedal | ||
+ | * Be sure to clean up and turn main power off when done | ||
+ | * SIN - auto retracts, single cut | ||
+ | * INCH - holds position when you tap | ||
+ | * AUTO - repeats the cutting operation as long as you hold it down | ||
+ | * Upgrades | ||
+ | * Add a sheet metal cover to prevent stuff from falling in. | ||
+ | * Drop superglue onto light switch to ensure it stays on | ||
+ | * Replace power LED indicator so there' |
tools/metal_shear/clearance.txt · Last modified: 2024/03/21 11:54 by smartin015