tools:metal_lathe:clearance
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| tools:metal_lathe:clearance [2023/09/24 16:36] – removed - external edit (Unknown date) 127.0.0.1 | tools:metal_lathe:clearance [2024/02/07 23:34] (current) – smartin015 | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| + | ====== Metal Lathe Clearance====== | ||
| + | |||
| + | {{section> | ||
| + | |||
| + | ====== Tool Specific Instruction ====== | ||
| + | |||
| + | ===== Point out the following tool features ===== | ||
| + | |||
| + | * Maintenance Tag | ||
| + | * E-Stop | ||
| + | * Spindle on/off, foot brake (if applicable) | ||
| + | * Spindle direction control | ||
| + | * Spindle speed controls | ||
| + | * Headstock, spindle | ||
| + | * Chuck, chuck jaws, chuck key | ||
| + | * Collets & draw tube | ||
| + | * Bed and ways | ||
| + | * Saddle/ | ||
| + | * Carriage handwheel | ||
| + | * Crossfeed/ | ||
| + | * Compound handle & angle adjustment | ||
| + | * Toolpost lock & rotation handles/ | ||
| + | * Travel locks and limits | ||
| + | * Tailstock handle, locks | ||
| + | * Turning, facing, and boring tools | ||
| + | |||
| + | ===== Identify & mitigate common hazards ===== | ||
| + | |||
| + | * Heavy things - chucks & workpieces | ||
| + | * Sharp things - cutting tools, chips, burrs on work piece | ||
| + | * Spinning things - chuck jaws, work piece, lead screw | ||
| + | * Hot things - chips, work piece, tools | ||
| + | |||
| + | ===== Allowable Materials ===== | ||
| + | |||
| + | * Can name three materials allowed on the lathe | ||
| + | * Can name materials that are not allowed on the lathe | ||
| + | |||
| + | ===== Safe Setup/ | ||
| + | |||
| + | * Demonstrates proper removal and mounting of chuck (cleans nose, correct force) | ||
| + | * Demonstrates proper work-holding in 3 jaw chuck | ||
| + | * Demonstrates proper feed and speed selection | ||
| + | * Demonstrates proper cutting tool selection | ||
| + | * Demonstrates proper mounting of cutting tool in toolpost | ||
| + | * Demonstrates turning and facing | ||
| + | * Demonstrates center drilling with tailstock | ||
| + | * Demonstrates cleaning the lathe | ||
| + | |||
| + | ===== Knowledge and Technique ===== | ||
| + | |||
| + | * Knows how and when to support stock with long stick-out | ||
| + | * Knows use of turning, facing, and boring tools, correct orientation & stick-out | ||
| + | |||
| + | ===== Tool Tutorial ===== | ||
| + | [[tools: | ||
| + | |||