Differences

This shows you the differences between two versions of the page.

--- damage_policy [2023/02/19 16:22] – jeffbearer
+++ damage_policy [2023/08/07 16:11] (current) – removed jeffbearer
@@ Line 1: / Line 1: @@
-====== Excessive Damage Policy ======
-As a member of Protohaven, you are expected to use our equipment with care and respect. However, we understand that accidents may happen and sometimes equipment may get damaged beyond normal wear and tear. In such cases, we have a policy that requires you to pay a fee to cover the cost of repairing or replacing the damaged equipment. The fee will be determined by staff and the tech leads based on the extent and nature of the damage. We appreciate your cooperation and honesty in reporting any damage that you may cause to our equipment. This policy is intended to protect our assets and ensure that all members can enjoy using our equipment in good condition.
-====== CNC Router Spoilboard ======
-Any user who cuts into the spoil board greater than 0.125 inches (1/8 inch) will be assessed a feed toward replacing the spoil board.  The fee will be $40 + $10 a square foot measured in whole square feet rounding up.
-This damage can be avoided by careful setup and if they wish members can affix their own sacrificial spoil board between the workpiece and the spoil board.
-====== Table Saw Fence Face ======
-Any user who had the saw blade contact the fence face marring the surface will be assessed a replacement fee of $50  This is a completely avoidable circumstance and a auxiliary fence is provided when members are doing cuts close to the fence.