====== Electric Slip Roll Clearance (DRAFT) ======

{{section>tools:clearance_template&noheader&nofooter}}

====== Tool Specific Instruction ======

===== Point out the following tool features =====

TODO

===== Identify & mitigate common hazards =====

TODO

===== Allowable Materials =====

TODO

===== Safe Setup/Operation/Cleanup =====

TODO

===== Knowledge and Technique =====

TODO

===== Notes =====

  * check your sleeves & loose fabric - bad!
  * Don't do rod or tubing. Sheet metal 16ga only
  * Blue bar is emergency stop, works in either direction
  * Lower idler roll in the back with the black handles - match sizes
  * Want metal going in and up, not digging in.
  * Back out both E stops (on machine and on pedestal)
  * Press power button, green light turns on
  * Make sure tension knobs on both sides are consistent - for top and bottom front roller
  * In/out step levers
  * Pull the lock on the right side of the top roll out to allow removing fully rounded pieces. Make sure to lock it afterwards!
  * Drill slip controler
  * Maintenance:
  * Every month - apply ways oil (from oil can resting on lathe) to metal bushings on idle roller. Spin the roller to make sure it moves freely